TOYOTA TACOMA (N220/N240/N250/N260/N270) 4.0L V6 VVT-i TRD 228kW/306HP DENSO

ECU DENSO 275036-5130 · 310 CV (228 kW) · 4000 cc · Benzina sovralimentato

ECU DatabaseTOYOTA › TOYOTA TACOMA (N220/N240/N250/N260/N270) 4.0L V6 VVT-i TRD 228kW/306HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 2 firmware versions

Vehicle data

BrandTOYOTA
ModelTACOMA (N220/N240/N250/N260/N270)
Engine4.0L V6 VVT-i TRD 228kW/306HP DENSO
Stock power310 CV / 228 kW
Displacement4000 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275036-5130
Memory / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Available tuning operations / options:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-YWG41- 1.67.0073YWG4100 DENSO 275036-5130
89663-YWG38- 1.67.0153YWG3800 DENSO 275036-5130

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata