TOYOTA LAND CRUISER PRADO (J150) 4.0L V6 24V VVT-i 232kW/311HP DENSO

ECU DENSO 275036-5130 · 315 CV (232 kW) · 4000 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA LAND CRUISER PRADO (J150) 4.0L V6 24V VVT-i 232kW/311HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 6 firmware versions

Vehicle data

BrandTOYOTA
ModelLAND CRUISER PRADO (J150)
Engine4.0L V6 24V VVT-i 232kW/311HP DENSO
Stock power315 CV / 232 kW
Displacement4000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275036-5130
Memory / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Available tuning operations / options:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware identifiers (6)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-60E53- 1.67.011360E5300 DENSO 275036-5130
89663-60E51- 1.67.012360E5100 DENSO 275036-5130
89663-60E50 1.67.005360E5000 DENSO 275036-5130
89663-60P01- 1.67.011360P0100 DENSO 275036-5130
89663-60P00- 1.67.004360P0000 DENSO 275036-5130
89663-60692- 1.67.01236069200 DENSO 275036-5130

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata