TOYOTA ESTIMA/PREVIA (XR50) 3.5L V6 24V 202kW/275HP DENSO

ECU DENSO 275036-2110 · 275 CV (202 kW) · 3500 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA ESTIMA/PREVIA (XR50) 3.5L V6 24V 202kW/275HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 4 firmware versions

Vehicle data

BrandTOYOTA
ModelESTIMA/PREVIA (XR50)
Engine3.5L V6 24V 202kW/275HP DENSO
Stock power275 CV / 202 kW
Displacement3500 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275036-2110
Memory / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Available tuning operations / options:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Gearbox maximum torque allowed
  • Advance limiter for component protection 1
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware identifiers (4)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-28392- 1.51.00432839200 DENSO 275036-2110
89663-28413- 1.51.03332841300 DENSO 275036-2110
89663-28390-A 1.51.01332839000 DENSO 275036-2110
89663-28A50- 1.51.007328A5000 DENSO 275036-2110

Vehicle technical notes

OBD located under the steering column, to the right of the pedalboard, accessible without removing anything.

ECU notes

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata