CAN-AM/BRP MAVERICK X3 900 18->20 67kW — ECU BOSCH ME17.8.5

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Get the file for this vehicle

Buy the file (original or remapped)Register on mastertuningfile.com and order the file

Are you a workshop or tuner?

Vehicle data

Brand	CAN-AM/BRP
Model	MAVERICK X3 900
Engine	18->20 67kW
Stock power	91 CV / 67 kW
Displacement	900 cc
Fuel	Benzina aspirato
Vehicle type	Moto

ECU

Manufacturer	BOSCH
Model	ME17.8.5
Memory / EPROM	MICRO ST TRICORE - 12032 Kbit - 178000

Available tuning operations / options:

Base timing
Lambda/AFR mixture for engine temperature at crancking
Optimal spark timing/MBT
Desired engine load calculation
Lambda correction for engine temperature after starting
Exhaust gas temperature
Expected vehicle speed
ECT for fan disengagement
ECT for fan engagement
Injector latency - cylinder 1
Injector latency - cylinder 2
INJSC
Torque limiter
Lambda enrichment for components protection
RPM Limiter
RPM Limiter 2
Gear dependent maximum engine speed
RPM limiter in limp mode
Maximum limitation Lambda sensor
Speed limiter based on gear
Speed limiter for key
Speed limiter - rear axle protection
Speed limiter for unknown gear
Map sensor offset
MAP sensor slope
Max MAP sensor voltage
Throttle air mass flow calculation
Min MAP sensor voltage
Max allowed torque for speed limit control
Optimal engine moment
RPM hysteresis above rev limit for fuel cut-off
Driver torque request
Throttle angle management
Torque limit table for IAT sensor
Torque limit for voltage
Target Lambda for knock protection
Torque limit table for ECT sensor
Volumetric efficiency
RPM threshold for 2 foot
Vehicle speed threshold for 2 foot

Firmware identifiers (1)

Hardware No.	Software No. (chip)	Version	Update software	ECU
F00HM00196	7E4163OH1VLS1	1.94.005	—	BOSCH ME17.8.5

ECU notes

MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Get the file for this vehicle

Buy the file (original or remapped)Register on mastertuningfile.com and order the file Are you a workshop or tuner?Offer these services yourself: activate your TuningFile platform

Tools to read and write this ECU

Flex Programmatore per rimappatura centraline e cambi automatici ECU + auto gearbox € 1.000 Buy

The Genius OBD + Bench € 2.500 Buy

Other CAN-AM/BRP

OUTLANDER XT 800
09->14 50kW COMMANDER 1000
18->20 66kW OUTLANDER 570
16->25 36kW MAVERICK 1000
16->20 75kW RENEGADE 800
09->14 54kW RENEGADE 1000
15->17 66kW COMMANDER 800
18->20 53kW MAVERICK Xds 1000
16->19 88kW OUTLANDER XT 400
14->18 28kW RENEGADE 500
09->14 34kW

→ All ECUs CAN-AM/BRP