LEXUS RX (AL10) 350 VVT-i 3.0L 205kW/275HP DENSO

ECU DENSO 275036-5920 · 279 CV (205 kW) · 3000 cc · Benzina sovralimentato

ECU-databaseLEXUS › LEXUS RX (AL10) 350 VVT-i 3.0L 205kW/275HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkLEXUS
ModelRX (AL10)
Motor350 VVT-i 3.0L 205kW/275HP DENSO
Standaard vermogen279 CV / 205 kW
Cilinderinhoud3000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-5920
Geheugen / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Lambda correction f(ECT) 4
  • Gearbox maximum torque allowed
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-48L11- 1.67.038348L1100 DENSO 275036-5920
89663-48C80-A 1.67.008348C8000 DENSO 275036-5920
89663-48L21- 1.67.004348L2100 DENSO 275036-5920
89663-48340-A 1.67.00934834000 DENSO 275036-5920

ECU-notities

Microprocessor NEC 76F0070 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata