LEXUS GX (J150) 460 4.6L V8 221kW/296HP VVT-i DENSO

ECU DENSO 275036-5920 · 300 CV (221 kW) · 4600 cc · Benzina aspirato

ECU-databaseLEXUS › LEXUS GX (J150) 460 4.6L V8 221kW/296HP VVT-i DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkLEXUS
ModelGX (J150)
Motor460 4.6L V8 221kW/296HP VVT-i DENSO
Standaard vermogen300 CV / 221 kW
Cilinderinhoud4600 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-5920
Geheugen / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Beschikbare tuning-opties:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(IAT) 2
  • Lambda correction f(ECT)
  • Gearbox maximum torque allowed
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-60K00- 1.67.005360K0000 DENSO 275036-5920
89663-60E74- 1.67.005360E7400 DENSO 275036-5920

ECU-notities

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata