BENTLEY CONTINENTAL GT SPEED 6.0L V12 BITURBO 460kW/617HP ME7.1.6

ECU BOSCH ME17.1.6 · 625 CV (46 kW) · 6000 cc · Benzina sovralimentato

ECU-databaseBENTLEY › BENTLEY CONTINENTAL GT SPEED 6.0L V12 BITURBO 460kW/617HP ME7.1.6

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkBENTLEY
ModelCONTINENTAL GT SPEED
Motor6.0L V12 BITURBO 460kW/617HP ME7.1.6
Standaard vermogen625 CV / 46 kW
Cilinderinhoud6000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME17.1.6
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Desired pressure ratio
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • MAF sensor calibration
  • Throttle air mass flow calculation
  • Max torque profile
  • Optimal engine moment
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation 2
  • Maximum pressure ratio limit depending on temperature
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.00.00407C906023BF 1346 BOSCH ME17.1.6

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata