VOLKSWAGEN TOUAREG (7P5) 4.2L V8 32V FSI 265kW/355HP MED17.1.1

ECU BOSCH MED17.1.1 · 360 CV (265 kW) · 4200 cc · Benzina aspirato

ECU DatabaseVOLKSWAGEN › VOLKSWAGEN TOUAREG (7P5) 4.2L V8 32V FSI 265kW/355HP MED17.1.1

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 2 firmware versions

Vehicle data

BrandVOLKSWAGEN
ModelTOUAREG (7P5)
Engine4.2L V8 32V FSI 265kW/355HP MED17.1.1
Stock power360 CV / 265 kW
Displacement4200 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.1
Memory / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

Available tuning operations / options:

  • Engine ignition timing versus temperature
  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Engine speed limitation at high motor temperature
  • Engine speed limit temperature based
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Throttle angle management

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1037531308 1.94.0097P0907560C 0001 BOSCH MED17.1.1
1.94.0267P0907560 0003 BOSCH MED17.1.1

ECU notes

MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop