SEAT LEON (1P) 1.4L 16V TSI 90kW/121HP MED17.5

ECU BOSCH MED17.5.20 · 122 CV (9 kW) · 1400 cc · Benzina sovralimentato

ECU DatabaseSEAT › SEAT LEON (1P) 1.4L 16V TSI 90kW/121HP MED17.5

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 12 firmware versions

Vehicle data

BrandSEAT
ModelLEON (1P)
Engine1.4L 16V TSI 90kW/121HP MED17.5
Stock power122 CV / 9 kW
Displacement1400 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.5.20
Memory / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

Available tuning operations / options:

  • Base timing
  • Optimal spark timing/MBT
  • Advance correction
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Exhaust gas temperature
  • Gearbox maximum torque allowed
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • High fuel pressure pump limit
  • High pressure fuel pump setpoint - limp home mode
  • High-pressure fuel pump - in catalyst heating monitoring mode
  • Intake valve lift
  • Intake valve lift - catalyst heating
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limiter 4
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Maximum intake manifold pressure
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode
  • Pressure ratio depending on IAT
  • Driver torque request
  • Driver torque request AWD
  • Driver torque request for reverse gear
  • Throttle angle management

Firmware identifiers (12)

Hardware No.Software No. (chip)VersionUpdate softwareECU
02612017871037507115 1.94.01203C906022B 6659 BOSCH MED17.5.20
02612017871037392145 1.94.01703C906022B 1960 BOSCH MED17.5.20
02612017871037515771 1.94.01103C906022B 8657 BOSCH MED17.5.20
02612017871037393747 1.94.01303C906022B 2346 BOSCH MED17.5.20
0261S043961037515772 1.94.02803C906022AQ 8658 BOSCH MED17.5.20
0261S043961037507116 1.94.01303C906022AQ 6660 BOSCH MED17.5.20
0261S043961037399087 1.94.01303C906022AQ 3641 BOSCH MED17.5.20
0261S043961037395630 1.94.04403C906022AQ 2734 BOSCH MED17.5.20
1.94.01603C906016AP 9086 BOSCH MED17.5.5
1.94.01503C906016AP 8179 BOSCH MED17.5.5
1.94.00403C906016CS 7006 BOSCH MED17.5.5
1.94.02303C906016AP 7461 BOSCH MED17.5.5

ECU notes

This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata WARNING! ECU MED9 - IX/CL = injection at full load, decrease the values to enrich the injection
MICRO Infineon Tricore TC1766 ATTENTION!! On this car only serial reprogramming is possible. This Setting File can be used for serial system NewGenius.
MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
MICRO Infineon Tricore TC1766 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):