PORSCHE 991.2 4.0L GT3 RS 382kW/512HP MED17.1.11

ECU BOSCH MED17.1.11 · 519 CV (382 kW) · 4000 cc · Benzina aspirato

ECU DatabasePORSCHE › PORSCHE 991.2 4.0L GT3 RS 382kW/512HP MED17.1.11

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 5 firmware versions

Vehicle data

BrandPORSCHE
Model991.2
Engine4.0L GT3 RS 382kW/512HP MED17.1.11
Stock power519 CV / 382 kW
Displacement4000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.11
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Firmware identifiers (5)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.94.00699161866108 3648 BOSCH MED17.1.11
1.94.00399161866109 3680 BOSCH MED17.1.11
1.94.00599161866209 3681 BOSCH MED17.1.11
1.94.00399161866408 3651 BOSCH MED17.1.11
1.94.00399161866309 3682 BOSCH MED17.1.11

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata