MERCEDES SL CLASS R231 SL350 3.5L V6 24V 225kW/302HP MED17.7.1/17.7.3

ECU BOSCH MED17.7.1/17.7.3 · 306 CV (225 kW) · 3500 cc · Benzina aspirato

ECU DatabaseMERCEDES › MERCEDES SL CLASS R231 SL350 3.5L V6 24V 225kW/302HP MED17.7.1/17.7.3

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandMERCEDES
ModelSL CLASS R231
EngineSL350 3.5L V6 24V 225kW/302HP MED17.7.1/17.7.3
Stock power306 CV / 225 kW
Displacement3500 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.7.1/17.7.3
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Advance correction
  • Desired engine load calculation
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • Maximum value for EKP (electric fuel pump)
  • Factor to correct fuel delivery system
  • Maximum value for HDP (high pressure fuel pump)
  • Advance limiter
  • Advance limiter for component protection 1
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • MAF sensor calibration
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max injection amount for each cylinder
  • Optimal engine moment
  • Torque/load reduction for overheating protection
  • Specific air mass flow quantity limiter
  • Driver torque request
  • Throttle angle management

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
00090403002769024500 1.94.0022769033701 BOSCH MED17.7.1/17.7.3

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata