MERCEDES E CLASS W212/S212 E63 AMG 5.5L V8 32V BITURBO 386kW/518HP MED17

ECU BOSCH MED17.7.1/17.7.3 · 525 CV (386 kW) · 5500 cc · Benzina sovralimentato

ECU DatabaseMERCEDES › MERCEDES E CLASS W212/S212 E63 AMG 5.5L V8 32V BITURBO 386kW/518HP MED17

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 13 firmware versions

Vehicle data

BrandMERCEDES
ModelE CLASS W212/S212
EngineE63 AMG 5.5L V8 32V BITURBO 386kW/518HP MED17
Stock power525 CV / 386 kW
Displacement5500 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.7.1/17.7.3
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Advance correction
  • Height correction for boost pressure
  • Desired engine load calculation
  • Compression ratio for turbocharger protection
  • Desired pressure ratio
  • Desired pressure ratio in Sport mode
  • Exhaust gas temperature
  • Maximum value for EKP (electric fuel pump)
  • Factor to correct fuel delivery system
  • Factor for reducing maximum filling
  • Maximum value for HDP (high pressure fuel pump)
  • High pressure fuel pump setpoint
  • Advance limiter for component protection 1
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Torque limiter at high EGT
  • Max desired pressure ratio limit
  • Max desired pressure ratio limit (Sport mode)
  • RPM Limiter
  • RPM limiter 3
  • RPM limit for EOT sensor
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • MAF sensor calibration
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max injection amount for each cylinder
  • Maximum negative deviation for boost overcharge
  • Max torque profile
  • Max torque profile (overboost active)
  • Max torque profile in Sport mode
  • Optimal engine moment
  • Torque/load reduction for overheating protection
  • Power limit torque table
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Specific air mass flow quantity limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency

Firmware identifiers (13)

Hardware No.Software No. (chip)VersionUpdate softwareECU
00090401001579020200 1.94.0281579031000 BOSCH MED17.7.1/17.7.3
00090401001579020000 1.94.0191579030600 BOSCH MED17.7.1/17.7.3
00090403002789021600 1.94.0221579031500 BOSCH MED17.7.1/17.7.3
00090403001579020400 1.94.0221579031900 BOSCH MED17.7.1/17.7.3
00090403002789023300 1.94.0231579035800 BOSCH MED17.7.1/17.7.3
00090403002789021200 1.94.0311579032400 BOSCH MED17.7.1/17.7.3
00090403002789022500 1.94.0151579032600 BOSCH MED17.7.1/17.7.3
00090403002789023100 1.94.0201579034300 BOSCH MED17.7.1/17.7.3
00090403002789023100 1.94.0281579034300 BOSCH MED17.7.1/17.7.3
00090403002789021200 1.94.0301579032000 BOSCH MED17.7.1/17.7.3
00090403002789023300 1.94.0151579035800 BOSCH MED17.7.1/17.7.3
00090403001579020200 1.94.0121579031000 BOSCH MED17.7.1/17.7.3
00090403002789022500 1.94.0341579033700 BOSCH MED17.7.1/17.7.3

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata