MERCEDES E CLASS W211 E500 5.5L V8 285kW/383HP ME9.7

ECU BOSCH ME9.7 · 388 CV (285 kW) · 5500 cc · Benzina aspirato

ECU DatabaseMERCEDES › MERCEDES E CLASS W211 E500 5.5L V8 285kW/383HP ME9.7

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 2 firmware versions

Vehicle data

BrandMERCEDES
ModelE CLASS W211
EngineE500 5.5L V8 285kW/383HP ME9.7
Stock power388 CV / 285 kW
Displacement5500 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelME9.7
Memory / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Available tuning operations / options:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Torque limiter at high EGT
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
00344670402739020100 1.79.0192739030300 BOSCH ME9.7
00344670402739020000 1.79.0212739031100 BOSCH ME9.7

ECU notes

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata