BMW 5 SERIES GT F07 535i 3.0L L6 24V 225kW/302HP MEVD17.2.G

ECU BOSCH MEVD17.2.G · 306 CV (225 kW) · 3000 cc · Benzina aspirato

ECU DatabaseBMW › BMW 5 SERIES GT F07 535i 3.0L L6 24V 225kW/302HP MEVD17.2.G

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandBMW
Model5 SERIES GT F07
Engine535i 3.0L L6 24V 225kW/302HP MEVD17.2.G
Stock power306 CV / 225 kW
Displacement3000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMEVD17.2.G
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Boost pressure
  • Boost pressure 2
  • Desired engine load calculation
  • Maximum torque limitation at clutch
  • Characteristic line correction factor for pressure ratio for turbocharger overspeed protection
  • Gearbox maximum torque allowed
  • HFM/HLM threshold for diagnosis
  • High pressure fuel pump setpoint
  • Intake valve lift
  • Intake valve lift - full load
  • Torque limiter 2
  • L
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Maximum pressure ratio limit depending on ECT
  • Requested engine filling
  • Driver torque request
  • Wastegate duty-cycle

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
000019DC014502000021571DB401 1.98.003000025091DB407 BOSCH MEVD17.2.G

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata