AUDI A3 (8P) 1.6L 16V FSI 85kW/114HP MED9.5.10

ECU BOSCH MED9.5.10 · 116 CV (85 kW) · 1600 cc · Benzina aspirato

ECU DatabaseAUDI › AUDI A3 (8P) 1.6L 16V FSI 85kW/114HP MED9.5.10

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 2 firmware versions

Vehicle data

BrandAUDI
ModelA3 (8P)
Engine1.6L 16V FSI 85kW/114HP MED9.5.10
Stock power116 CV / 85 kW
Displacement1600 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED9.5.10
Memory / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Available tuning operations / options:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Torque limiter 2
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Throttle angle management

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
0261S020211037382143 1.85.01203C906056AE 9275 BOSCH MED9.5.10
0261S023791037382597 1.85.01703C906056ED 0236 BOSCH MED9.5.10

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU located in the engine bay behind/close to the battery. Difficulty: easy

ECU notes

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocesor Motorola MPC561/2/3/4. WARNING! ECU MED9 - IX/CL = injection at full load, decrease the values to enrich the injection This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocesor Motorola MPC561/2/3/4. This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata WARNING! ECU MED9 - IX/CL = injection at full load, decrease the values to enrich the injection

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop