TOYOTA YARIS (XP90) 1.3L 16V VVT-i 64kW/86HP DENSO

ECU DENSO 275036-1152 · 87 CV (64 kW) · 1300 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA YARIS (XP90) 1.3L 16V VVT-i 64kW/86HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelYARIS (XP90)
Motor1.3L 16V VVT-i 64kW/86HP DENSO
Standaard vermogen87 CV / 64 kW
Cilinderinhoud1300 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-1152
Geheugen / EPROMMICRO NEC 76F0039GD - 512 Kbit - 80000

Beschikbare tuning-opties:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 2
  • Variable valve timing - inlet

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-0D121- 1.67.03530D12100 DENSO 275036-1152
89663-0D120- 1.67.01230D12000 DENSO 275036-1152
89663-0D130- 1.67.02030D13000 DENSO 275036-1152
89663-0D122- 1.67.00730D12200 DENSO 275036-1152
89663-0D131- 1.67.00730D13100 DENSO 275036-1152

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata