TOYOTA VIOS (XP90) 1.5L 16V VVT-i 81kW/109HP DENSO 275036

ECU DENSO 275036-1150 · 110 CV (81 kW) · 1500 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA VIOS (XP90) 1.5L 16V VVT-i 81kW/109HP DENSO 275036

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 7 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelVIOS (XP90)
Motor1.5L 16V VVT-i 81kW/109HP DENSO 275036
Standaard vermogen110 CV / 81 kW
Cilinderinhoud1500 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-1150
Geheugen / EPROMMICRO NEC 76F0039GD - 512 Kbit - 80000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-52841- 1.67.00635284100 DENSO 275036-1150
89663-52G10- 1.67.007352G1000 DENSO 275036-1150
89663-0D540- 1.67.00630D54000 DENSO 275036-1152
89663-0D531- 1.67.00530D53100 DENSO 275036-1152
89663-0D532- 1.67.00330D53200 DENSO 275036-1152
89663-0D530- 1.67.00430D53000 DENSO 275036-1152
89663-0D542- 1.67.00730D54200 DENSO 275036-1152

ECU-notities

This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata