TOYOTA VIOS (XP90) 1.5L 16V VVT-i 81kW/109HP DENSO 211941

ECU DENSO 211941-45900930 · 110 CV (81 kW) · 1500 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA VIOS (XP90) 1.5L 16V VVT-i 81kW/109HP DENSO 211941

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelVIOS (XP90)
Motor1.5L 16V VVT-i 81kW/109HP DENSO 211941
Standaard vermogen110 CV / 81 kW
Cilinderinhoud1500 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model211941-45900930
Geheugen / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-0DG20- 1.67.02330DG2000 DENSO 211941-45900930
89663-0DG22- 1.67.00930DG2200 DENSO 211941-45900930
89663-0DE72- 1.67.00330DE7200 DENSO 211941-46000930
89663-0DE70- 1.67.01130DE7000 DENSO 211941-46000930
89663-0DE82- 1.67.01530DE8200 DENSO 211941-46000930

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata