TOYOTA VERSO (AR20) 2.0L 16V D-4D 101kW/136HP DENSO

ECU DENSO 175822-762 · 137 CV (101 kW) · 2000 cc · Diesel sovralimentato

ECU-databaseTOYOTA › TOYOTA VERSO (AR20) 2.0L 16V D-4D 101kW/136HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelVERSO (AR20)
Motor2.0L 16V D-4D 101kW/136HP DENSO
Standaard vermogen137 CV / 101 kW
Cilinderinhoud2000 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model175822-762
Geheugen / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • Boost pressure 3
  • EGR valve control
  • EGR valve control 2
  • Variable boost pressure 1
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Injection 2
  • Injection 3
  • Injection 4
  • Maximum possible engine charge
  • Main injection
  • Specific injection pressure
  • Air mass flow
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 3

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-0F110- 1.51.00830F11000 DENSO 175822-762
89663-0F163- 1.67.00330F16300 DENSO 275922-022

Technische voertuignotities

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata