TOYOTA RAV4 (XA30) 2.0L 16V 116kW/156HP DENSO

ECU DENSO 275036-6941 · 158 CV (116 kW) · 2000 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA RAV4 (XA30) 2.0L 16V 116kW/156HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelRAV4 (XA30)
Motor2.0L 16V 116kW/156HP DENSO
Standaard vermogen158 CV / 116 kW
Cilinderinhoud2000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-6941
Geheugen / EPROMMICRO NEC 76F0040GD - 512 Kbit - 80000

Beschikbare tuning-opties:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-42590- 1.51.01434259000 DENSO 275036-6941
89663-42B80- 1.67.027342B8000 DENSO 275922-5280/5380
89663-42F52- 1.67.004342F5200 DENSO 275922-5280/5380
89663-42B82- 1.67.009342B8200 DENSO 275922-5280/5380

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0040GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata