TOYOTA RAV4 (XA30) 2.0L 16V 112kW/150HP DENSO

ECU DENSO 275036-1152 · 152 CV (112 kW) · 2000 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA RAV4 (XA30) 2.0L 16V 112kW/150HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelRAV4 (XA30)
Motor2.0L 16V 112kW/150HP DENSO
Standaard vermogen152 CV / 112 kW
Cilinderinhoud2000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-1152
Geheugen / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-0R021- 1.67.01530R02100 DENSO 275036-1152
89663-42601- 1.67.00534260100 DENSO 275036-1152
89663-0R020- 1.67.00530R02000 DENSO 275036-1152
89663-42602- 1.67.00734260200 DENSO 275036-1152
275100-372189663-42610-A 1.67.01934261000 DENSO 275036-1152

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata