TOYOTA LAND CRUISER (J70) 4.0L V6 168kW/228HP DENSO

ECU DENSO 275136-2010 · 228 CV (168 kW) · 4000 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA LAND CRUISER (J70) 4.0L V6 168kW/228HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelLAND CRUISER (J70)
Motor4.0L V6 168kW/228HP DENSO
Standaard vermogen228 CV / 168 kW
Cilinderinhoud4000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275136-2010
Geheugen / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3
  • Variable valve timing - inlet

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-60E91- 1.67.010360K5000 DENSO 275136-2010
89663-6A160- 1.67.00636A16000 DENSO 275136-2010
89663-60K52- 1.67.016360K5200 DENSO 275136-2010
89663-60K51- 1.67.012360K5100 DENSO 275136-2010

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata