TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 210kW/286HP DENSO

ECU DENSO 275922-001 · 286 CV (21 kW) · 4500 cc · Diesel sovralimentato

ECU-databaseTOYOTA › TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 210kW/286HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 5 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelLAND CRUISER (J200)
Motor4.5L V8 32V D-4D 210kW/286HP DENSO
Standaard vermogen286 CV / 21 kW
Cilinderinhoud4500 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275922-001
Geheugen / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Beschikbare tuning-opties:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • Boost pressure 3
  • EGR valve control
  • Variable boost pressure 1
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Speed limiter
  • Maximum possible engine charge
  • Specific injection pressure limiter
  • Specific injection pressure
  • Air mass flow
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 3

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-60B01- 1.51.005360B0100 DENSO 275922-001
89663-60V51- 1.67.002360V5100 DENSO 275922-001
89663-60A63- 1.51.002360A6300 DENSO 275922-001
89663-60A61- 1.51.009360A6100 DENSO 275922-001
89663-60B03- 1.51.003360B0300 DENSO 275922-001

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

→ See all add-on modules on the shop