TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 186kW/249HP DENSO

ECU DENSO 275922-001 · 252 CV (186 kW) · 4500 cc · Diesel sovralimentato

ECU-databaseTOYOTA › TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 186kW/249HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 7 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelLAND CRUISER (J200)
Motor4.5L V8 32V D-4D 186kW/249HP DENSO
Standaard vermogen252 CV / 186 kW
Cilinderinhoud4500 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275922-001
Geheugen / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Beschikbare tuning-opties:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • Boost pressure 3
  • Boost pressure 4
  • EGR valve control
  • Variable boost pressure 1
  • Variable boost pressure 2
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit 2
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • Torque limiter 2
  • Torque limiter
  • Speed limiter
  • Specific injection pressure
  • Air mass flow
  • Driver torque request
  • Variable geometry duty cycle limit

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-60V50- 1.67.002360V5000 DENSO 275922-001
89663-60U80- 1.67.013360U8000 DENSO 275922-001
89663-60U92- 1.67.004360U9200 DENSO 275922-001
89663-60U91- 1.67.003360U9100 DENSO 275922-001
89663-60U90-A 1.67.007360U9000 DENSO 275922-001
89663-60U93- 1.67.003360U9300 DENSO 275922-001
89663-60U94- 1.67.003360U9400 DENSO 275922-001

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata