TOYOTA IQ (AJ10) 1.3L 16V VVT-i 72kW/97HP DENSO

ECU DENSO 275036-5280 · 98 CV (72 kW) · 1300 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA IQ (AJ10) 1.3L 16V VVT-i 72kW/97HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 7 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelIQ (AJ10)
Motor1.3L 16V VVT-i 72kW/97HP DENSO
Standaard vermogen98 CV / 72 kW
Cilinderinhoud1300 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-5280
Geheugen / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Beschikbare tuning-opties:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • L
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-YWP04- 1.67.0123YWP0400 DENSO 275036-5280
89663-74080-B 1.67.01037408000 DENSO 275036-5280
89663-74122- 1.67.00537412200 DENSO 275922-5280
89663-74370- 1.67.00437437000 DENSO 275922-5280
89663-74250- 1.67.00537425000 DENSO 275922-5280
89663-74370- 1.67.00837437000 DENSO 275922-5280
89663-74190- 1.67.01237419000 DENSO 275922-5280

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata