TOYOTA IQ (AJ10) 1.0L 12V VVT-i 50kW/68HP DENSO

ECU DENSO 211841-3781A890 · 68 CV (5 kW) · 1000 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA IQ (AJ10) 1.0L 12V VVT-i 50kW/68HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 9 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelIQ (AJ10)
Motor1.0L 12V VVT-i 50kW/68HP DENSO
Standaard vermogen68 CV / 5 kW
Cilinderinhoud1000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model211841-3781A890
Geheugen / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Injection correction
  • Advance limiter for component protection 1
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 2
  • Variable valve timing - inlet

Firmware-identificatoren (9)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-74400- 1.67.02137440000 DENSO 211841-3781A890
89663-74042- 1.67.00537404200 DENSO 211941-37900830
89663-74181- 1.67.01037418100 DENSO 211941-37900830
89663-74034- 1.67.00837403400 DENSO 211941-37900830
89663-74041- 1.67.00837404100 DENSO 211941-37900830
89663-74040- 1.67.02237404000 DENSO 211941-37900830
89663-74061- 1.67.01937406100 DENSO 275036-9170
89663-74062- 1.67.00937406200 DENSO 275036-9170
89663-74060- 1.67.00537406000 DENSO 275036-9170

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0040GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata