TOYOTA DYNA 3.0L 16V D-4D 80kW/107HP DENSO

ECU DENSO 175822-887 · 109 CV (8 kW) · 3000 cc · Diesel sovralimentato

ECU-databaseTOYOTA › TOYOTA DYNA 3.0L 16V D-4D 80kW/107HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 8 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelDYNA
Motor3.0L 16V D-4D 80kW/107HP DENSO
Standaard vermogen109 CV / 8 kW
Cilinderinhoud3000 cc
BrandstofDiesel sovralimentato
VoertuigtypeLCV

ECU

FabrikantDENSO
Model175822-887
Geheugen / EPROMMICRO NEC 76F0040GD - 512 Kbit - 80000

Beschikbare tuning-opties:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • EGR valve control
  • Variable boost pressure 1
  • Variable boost pressure 2
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit 2
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Torque limiter
  • Maximum possible engine charge
  • Maximum relative engine air charge
  • Specific injection pressure limiter
  • Specific injection pressure
  • Air mass flow
  • Driver torque request
  • Variable geometry duty cycle limit

Firmware-identificatoren (8)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-25102- 1.67.00432510200 DENSO 175822-887
89663-25101- 1.67.00332510100 DENSO 175822-887
89663-25100- 1.67.00432510000 DENSO 175822-887
89663-25111- 1.00.00632511100 DENSO 175822-887
89663-25210- 1.67.00432521000 DENSO 175822-887
89663-25176- 1.67.00232517600 DENSO 275922-022
89663-25321- 1.67.01632532100 DENSO 275922-022
89663-25461- 1.67.00632546100 DENSO 275922-022

ECU-notities

Microprocessor NEC 76F0040GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata