TOYOTA CROWN (S180) 3.0L V6 167kW/224HP DENSO

ECU DENSO 275036-3410 · 227 CV (167 kW) · 3000 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA CROWN (S180) 3.0L V6 167kW/224HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelCROWN (S180)
Motor3.0L V6 167kW/224HP DENSO
Standaard vermogen227 CV / 167 kW
Cilinderinhoud3000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-3410
Geheugen / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-0N110- 1.51.00930N11000 DENSO 275036-3410

ECU-notities

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata