TOYOTA COROLLA (E140/E150) 2.0L L4 16V XEI VVT-i 112kW/150HP DENSO

ECU DENSO 211941-37000930 · 152 CV (112 kW) · 2000 cc · Benzina sovralimentato

ECU-databaseTOYOTA › TOYOTA COROLLA (E140/E150) 2.0L L4 16V XEI VVT-i 112kW/150HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelCOROLLA (E140/E150)
Motor2.0L L4 16V XEI VVT-i 112kW/150HP DENSO
Standaard vermogen152 CV / 112 kW
Cilinderinhoud2000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model211941-37000930
Geheugen / EPROMMICRO NEC 76F0039GD - 512 Kbit - 80000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • % relative air filling limit depending on IAT
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 2
  • Variable valve timing - inlet

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-12421- 1.51.01331242100 DENSO 211941-37000930
89663-02L10- 1.67.010302L1000 DENSO 275036-4820
89663-02L11- 1.67.013302L1100 DENSO 275036-4820
89663-02L12- 1.67.014302L1200 DENSO 275036-4820

Technische voertuignotities

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata