Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
✓ Aanvullende module beschikbaar 5 firmwareversies
Voertuiggegevens
| Merk | TOYOTA |
| Model | CAMRY (XV40) |
| Motor | 3.5L V6 24V 206kW/276HP DENSO |
| Standaard vermogen | 280 CV / 206 kW |
| Cilinderinhoud | 3500 cc |
| Brandstof | Benzina aspirato |
| Voertuigtype | Auto |
ECU
| Fabrikant | DENSO |
| Model | 275036-2110 |
| Geheugen / EPROM | MICRO NEC 76F0038AGD - 6144 Kbit - C0000 |
Beschikbare tuning-opties:
- Spark advance correction for ECT sensor
- Requested spark advance - high octane
- Requested spark advance - low octane
- Spark advance correction - valve timing position 1
- Spark advance correction - valve timing position 2
- Electronic throttle control
- Electronic throttle control 2
- Electronic throttle control 3
- Lambda correction f(IAT)
- Lambda correction f(ECT)
- Lambda correction f(ECT) 2
- Lambda correction f(ECT) 3
- Gearbox maximum torque allowed
- Advance limiter for component protection 1
- Torque limiter
- Lambda enrichment - open loop
- RPM Limiter
- Lambda driver wish
- Speed limiter
- % relative air filling limit depending on IAT
- Driver torque request
- Exhaust gas temperature sensor
- Variable valve timing - inlet
- Variable valve timing - outlet
Firmware-identificatoren (5)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| — | 89663-33653- |
1.51.010 | 33365300 |
DENSO 275036-2110 |
| — | 89663-06630-A |
1.51.057 | 30663000 |
DENSO 275036-2110 |
| — | 89663-YW300- |
1.51.032 | 3YW30000 |
DENSO 275036-2110 |
| — | 89663-33651- |
1.51.006 | 33365100 |
DENSO 275036-2110 |
| — | 89663-33652- |
1.51.013 | 33365200 |
DENSO 275036-2110 |
Technische voertuignotities
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU-notities
Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
