TOYOTA 4RUNNER (N210) 4.0L V6 24V VVT-i 185kW/248HP DENSO

ECU DENSO 275036-0360 · 252 CV (185 kW) · 4000 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA 4RUNNER (N210) 4.0L V6 24V VVT-i 185kW/248HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 7 firmwareversies

Voertuiggegevens

MerkTOYOTA
Model4RUNNER (N210)
Motor4.0L V6 24V VVT-i 185kW/248HP DENSO
Standaard vermogen252 CV / 185 kW
Cilinderinhoud4000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-0360
Geheugen / EPROMMICRO NEC 76F0038GD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Lambda driver wish 2
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3
  • Variable valve timing - inlet

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-35430- 1.67.00733543000 DENSO 275036-0360
89663-60561- 1.67.01036056100 DENSO 275036-0360
89663-35343- 1.67.00633534300 DENSO 275036-0360
89663-35370-A 1.67.02033537000 DENSO 275036-0360
89663-35350-A 1.67.00533535000 DENSO 275036-0360
89663-35372- 1.67.00633537200 DENSO 275036-0360
89663-35362- 1.67.00533536200 DENSO 275036-0360

Technische voertuignotities

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU-notities

Microprocessor NEC 76F0038GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata