SEA-DOO GTI SE 130 1.6L 16V 97kW/130HP ME17.8.5

ECU BOSCH ME17.8.5 · 132 CV (97 kW) · 1600 cc · Benzina aspirato

ECU-databaseSEA-DOO › SEA-DOO GTI SE 130 1.6L 16V 97kW/130HP ME17.8.5

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkSEA-DOO
ModelGTI
MotorSE 130 1.6L 16V 97kW/130HP ME17.8.5
Standaard vermogen132 CV / 97 kW
Cilinderinhoud1600 cc
BrandstofBenzina aspirato
VoertuigtypeMarine

ECU

FabrikantBOSCH
ModelME17.8.5
Geheugen / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

Beschikbare tuning-opties:

  • Base timing
  • Lambda/AFR mixture for engine temperature at crancking
  • Optimal spark timing/MBT
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Expected vehicle speed
  • Injector scaling - cylinder 1
  • Injector scaling - cylinder 2
  • Torque limiter
  • RPM Limiter
  • RPM Limiter 2
  • Gear dependent maximum engine speed
  • RPM limiter in limp mode
  • Maximum limitation Lambda sensor
  • Speed limiter - rear axle protection
  • Map sensor offset
  • MAP sensor slope
  • Max MAP sensor voltage
  • Throttle air mass flow calculation
  • Min MAP sensor voltage
  • Max allowed torque for speed limit control
  • RPM hysteresis above rev limit for fuel cut-off
  • Throttle angle management
  • Target Lambda for knock protection

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
F00HM001487A1124OG1FOS1 1.94.002 BOSCH ME17.8.5
F00HM001967A1163QK1FOS1 1.94.002 BOSCH ME17.8.5

ECU-notities

MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata