SEA-DOO RXT-X 1.5L 3 Cyl. SC 190kW/255HP ME17.8.5

ECU BOSCH ME17.8.5 · 259 CV (19 kW) · 1500 cc · Benzina sovralimentato

ECU-databaseSEA-DOO › SEA-DOO RXT-X 1.5L 3 Cyl. SC 190kW/255HP ME17.8.5

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkSEA-DOO
ModelRXT-X
Motor1.5L 3 Cyl. SC 190kW/255HP ME17.8.5
Standaard vermogen259 CV / 19 kW
Cilinderinhoud1500 cc
BrandstofBenzina sovralimentato
VoertuigtypeMarine

ECU

FabrikantBOSCH
ModelME17.8.5
Geheugen / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

Beschikbare tuning-opties:

  • Base timing
  • Lambda/AFR mixture for engine temperature at crancking
  • Optimal spark timing/MBT
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Expected vehicle speed
  • Injector scaling - cylinder 1
  • Injector scaling - cylinder 2
  • RPM Limiter
  • RPM Limiter 2
  • Gear dependent maximum engine speed
  • RPM limiter in limp mode
  • Maximum limitation Lambda sensor
  • Map sensor offset
  • MAP sensor slope
  • Max MAP sensor voltage
  • Throttle air mass flow calculation
  • Min MAP sensor voltage
  • RPM hysteresis above rev limit for fuel cut-off
  • Throttle angle management
  • Target Lambda for knock protection
  • Turbocharger volumetric efficiency

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
F00HM000717A10112T4RWP0 1.94.019 BOSCH ME17.8.5
F00HM001967E5169OE6VES1 1.94.011 BOSCH ME17.8.5

ECU-notities

MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata