MERCEDES SL CLASS R230 SL63 AMG 6.2L V8 386kW/518HP ME9.7

ECU BOSCH ME9.7 · 525 CV (386 kW) · 6200 cc · Benzina sovralimentato

ECU-databaseMERCEDES › MERCEDES SL CLASS R230 SL63 AMG 6.2L V8 386kW/518HP ME9.7

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 3 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelSL CLASS R230
MotorSL63 AMG 6.2L V8 386kW/518HP ME9.7
Standaard vermogen525 CV / 386 kW
Cilinderinhoud6200 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME9.7
Geheugen / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00444637400009024201 1.79.0130009030300 BOSCH ME9.7
00444637400104481340 1.79.0150074470040 BOSCH ME9.7
00444637400009024201 1.79.0060009033300 BOSCH ME9.7

ECU-notities

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata