MERCEDES S CLASS W221 S65 AMG 6.0L V12 TWINTURBO 450kW/604HP ME2.7.2

ECU BOSCH ME2.7.2 · 612 CV (45 kW) · 6000 cc · Benzina sovralimentato

ECU-databaseMERCEDES › MERCEDES S CLASS W221 S65 AMG 6.0L V12 TWINTURBO 450kW/604HP ME2.7.2

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 3 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelS CLASS W221
MotorS65 AMG 6.0L V12 TWINTURBO 450kW/604HP ME2.7.2
Standaard vermogen612 CV / 45 kW
Cilinderinhoud6000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME2.7.2
Geheugen / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Beschikbare tuning-opties:

  • Base timing
  • Lambda/AFR full load/WOT
  • Optimal spark timing/MBT
  • Boost pressure limiter for diagnostics
  • Boost pressure limit control
  • Boost limiter correction for APS/BPS sensor
  • Engine filling management
  • Filling factor limit
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM limiter for LSD
  • RPM limiter - N
  • Lambda reference
  • Boost pressure linearization
  • Knock detection factor
  • Knock detection factor - left bank
  • Speed limiter
  • Speed limiter 2
  • Speed limiter 3
  • Speed limiter 4
  • Relative permissible torque from the pedal position in torque limitation
  • Maximum pressure ratio limit depending on temperature
  • Requested engine filling
  • Driver torque request
  • Variable intake pulsation correction

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
0800121700D91SA003 1.16.020 BOSCH ME2.7.2
4340061500D65SA000 1.16.015 BOSCH ME2.7.2
7840100300D93SB000 1.16.009 BOSCH ME2.7.2

ECU-notities

Original EPROM PSOP 44 pins 29F400BB. In order to read and write this EPROM with the programmer you need the adapter for PSOP and the card 01B with EMP20, or 202B with EMP21. On this epron can be set a KEY.
Original EPROM PSOP 44 pins 29F400BB. To work on this ECU you can use NewTrasdata In order to read and write this EPROM with the programmer you need the adapter for PSOP and the card 01B with EMP20, or 202B with EMP21. On this epron can be set a KEY.