MERCEDES S CLASS W221 S300 3.0L V6 170kW/228HP ME9.7

ECU BOSCH ME9.7 · 231 CV (17 kW) · 3000 cc · Benzina aspirato

ECU-databaseMERCEDES › MERCEDES S CLASS W221 S300 3.0L V6 170kW/228HP ME9.7

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelS CLASS W221
MotorS300 3.0L V6 170kW/228HP ME9.7
Standaard vermogen231 CV / 17 kW
Cilinderinhoud3000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME9.7
Geheugen / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00344677400054487040 1.79.0020034478440 BOSCH ME9.7
00344677400054487040 1.79.0080044476140 BOSCH ME9.7
00344677402729020000 1.79.0062729033000 BOSCH ME9.7
00344677400054487040 1.79.0140034478640 BOSCH ME9.7

ECU-notities

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata