MERCEDES GLK CLASS X204 GLK300 3.0L V6 170kW/228HP ME9.7

ECU BOSCH ME9.7 · 231 CV (17 kW) · 3000 cc · Benzina aspirato

ECU-databaseMERCEDES › MERCEDES GLK CLASS X204 GLK300 3.0L V6 170kW/228HP ME9.7

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 6 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelGLK CLASS X204
MotorGLK300 3.0L V6 170kW/228HP ME9.7
Standaard vermogen231 CV / 17 kW
Cilinderinhoud3000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME9.7
Geheugen / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (6)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00344677402729020000 1.79.0042729033000 BOSCH ME9.7
00344677402729020900 1.79.0072729035000 BOSCH ME9.7
00344677402729020900 1.79.002381B22B152 BOSCH ME9.7
00344677402729020000 1.79.0062729033800 BOSCH ME9.7
00344677400104481840 1.79.0230074471340 BOSCH ME9.7
00344677402729020900 1.79.0082729034200 BOSCH ME9.7

ECU-notities

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop