MERCEDES GLE CLASS W166 350 3.5L V6 186kW/250HP MED17.7.3

ECU BOSCH MED17.7.1/17.7.3 · 253 CV (186 kW) · 3500 cc · Benzina sovralimentato

ECU-databaseMERCEDES › MERCEDES GLE CLASS W166 350 3.5L V6 186kW/250HP MED17.7.3

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 1 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelGLE CLASS W166
Motor350 3.5L V6 186kW/250HP MED17.7.3
Standaard vermogen253 CV / 186 kW
Cilinderinhoud3500 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.7.1/17.7.3
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Advance at part load
  • Advance correction
  • Desired engine load calculation
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • Maximum value for EKP (electric fuel pump)
  • Factor to correct fuel delivery system
  • Advance limiter for component protection 1
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • MAF sensor calibration
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max injection amount for each cylinder
  • Optimal engine moment
  • Torque/load reduction for overheating protection
  • Specific air mass flow quantity limiter
  • Driver torque request
  • Throttle angle management

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00090403002769020001 1.94.0132769038002 BOSCH MED17.7.1/17.7.3

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop