MERCEDES GLA CLASS X156 GLA45 AMG 2.0L 16V TURBO 280kW/375HP MED17.7.2

ECU BOSCH MED17.7.2 · 381 CV (28 kW) · 2000 cc · Benzina sovralimentato

ECU-databaseMERCEDES › MERCEDES GLA CLASS X156 GLA45 AMG 2.0L 16V TURBO 280kW/375HP MED17.7.2

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 4 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelGLA CLASS X156
MotorGLA45 AMG 2.0L 16V TURBO 280kW/375HP MED17.7.2
Standaard vermogen381 CV / 28 kW
Cilinderinhoud2000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.7.2
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Absolute boost limit
  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Ambient pressure threshold for boost diagnosis
  • Advance correction
  • Torque value while scavenging
  • Boost pressure limiter 2
  • Boost pressure
  • Boost pressure 2
  • Height correction for boost pressure
  • Desired engine load calculation
  • Compression ratio for turbocharger protection
  • Delta pressure for charging protection over diagnosis
  • Desired pressure ratio
  • Desired pressure ratio in Sport mode
  • Exhaust gas temperature
  • Maximum value for EKP (electric fuel pump)
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • Maximum value for HDP (high pressure fuel pump)
  • High pressure fuel pump setpoint
  • L
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Torque limiter at high EGT
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter - AT
  • Engine speed limit at high oil temperature
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • MAF sensor calibration
  • Maximum indicated torque
  • Maximum indicated torque (overboost active)
  • Boost pressure minimal delta
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max injection amount for each cylinder
  • Maximum intake manifold pressure
  • Maximum negative deviation for boost overcharge
  • Max torque profile
  • Max torque profile (overboost active)
  • Overboost range definition for maximum torque
  • Max torque profile in Sport mode
  • Optimal engine moment
  • Torque/load reduction for overheating protection
  • Power limit torque table
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Specific air mass flow quantity limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Torque limiter for the 1st gear selected
  • Torque limiter for selected gear
  • Throttle angle management
  • Transmission torque limit - clutch disengaged
  • Transmission torque limit - clutch disengaged . ESP deactivated
  • Transmission torque limit - clutch disengaged - reverse gear engaged
  • Transmission torque limitation at gs-messages interruption
  • Turbocharger volumetric efficiency

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
27090407001339021500 1.94.0181339032100 BOSCH MED17.7.2
27090407001339021400 1.94.0201339032000 BOSCH MED17.7.2
27090407001339021600 1.94.0031339033000 BOSCH MED17.7.2
27090407001339021500 1.94.0051339032200 BOSCH MED17.7.2

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop