MERCEDES CLS CLASS C219 CLS63 AMG 6.2L V8 32V 378kW/507HP ME9.7

ECU BOSCH ME9.7 · 514 CV (378 kW) · 6200 cc · Benzina aspirato

ECU-databaseMERCEDES › MERCEDES CLS CLASS C219 CLS63 AMG 6.2L V8 32V 378kW/507HP ME9.7

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelCLS CLASS C219
MotorCLS63 AMG 6.2L V8 32V 378kW/507HP ME9.7
Standaard vermogen514 CV / 378 kW
Cilinderinhoud6200 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME9.7
Geheugen / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00444637400104481340 1.79.0190074470140 BOSCH ME9.7
00444637400009024201 1.79.0230009030400 BOSCH ME9.7
00444637400084484440 1.79.0130054474240 BOSCH ME9.7
00444637400034489640 1.79.0150034471140 BOSCH ME9.7
00444637400064481740 1.79.0180034471640 BOSCH ME9.7

ECU-notities

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata