MERCEDES CLK CLASS C208/A208 CLK350 3.5L V6 200kW/268HP ME9.7

ECU BOSCH ME9.7 · 272 CV (2 kW) · 3500 cc · Benzina aspirato

ECU-databaseMERCEDES › MERCEDES CLK CLASS C208/A208 CLK350 3.5L V6 200kW/268HP ME9.7

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 3 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelCLK CLASS C208/A208
MotorCLK350 3.5L V6 200kW/268HP ME9.7
Standaard vermogen272 CV / 2 kW
Cilinderinhoud3500 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME9.7
Geheugen / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00244673400094489240 1.79.0040064475940 BOSCH ME9.7
00244673400054487040 1.79.0120044476240 BOSCH ME9.7
00244673400054481240 1.79.0080034477040 BOSCH ME9.7

ECU-notities

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata