MERCEDES A CLASS W176 A45 AMG 2.0L 16V TURBO 265kW/355HP MED17.7.2

ECU BOSCH MED17.7.2 · 360 CV (265 kW) · 2000 cc · Benzina sovralimentato

ECU-databaseMERCEDES › MERCEDES A CLASS W176 A45 AMG 2.0L 16V TURBO 265kW/355HP MED17.7.2

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 7 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelA CLASS W176
MotorA45 AMG 2.0L 16V TURBO 265kW/355HP MED17.7.2
Standaard vermogen360 CV / 265 kW
Cilinderinhoud2000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.7.2
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Absolute boost limit
  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Torque value while scavenging
  • Boost pressure
  • Boost pressure 2
  • Height correction for boost pressure
  • Desired engine load calculation
  • Compression ratio for turbocharger protection
  • Delta pressure for charging protection over diagnosis
  • Desired pressure ratio
  • Desired pressure ratio in Sport mode
  • Exhaust gas temperature
  • Maximum value for EKP (electric fuel pump)
  • Factor to correct fuel delivery system
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • Maximum value for HDP (high pressure fuel pump)
  • High pressure fuel pump setpoint
  • L
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Torque limiter at high EGT
  • RPM Limiter
  • RPM limiter 3
  • RPM limiter - AT
  • Engine speed limit at high oil temperature
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • MAF sensor calibration
  • Maximum indicated torque
  • Maximum indicated torque (overboost active)
  • Boost pressure minimal delta
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max injection amount for each cylinder
  • Maximum negative deviation for boost overcharge
  • Max torque profile
  • Max torque profile (overboost active)
  • Optimal engine moment
  • Boost pressure threshold cycles for the overboost recognition
  • Torque/load reduction for overheating protection
  • Power limit torque table
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Specific air mass flow quantity limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Torque limiter for the 1st gear selected
  • Torque limiter for selected gear
  • Throttle angle management
  • Transmission torque limit - clutch disengaged
  • Transmission torque limit - clutch disengaged . ESP deactivated
  • Transmission torque limit - clutch disengaged - reverse gear engaged
  • Transmission torque limitation at gs-messages interruption
  • Turbocharger volumetric efficiency

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
27090401001339020700 1.94.0321339030800 BOSCH MED17.7.2
27090401001339021300 1.94.0221339031900 BOSCH MED17.7.2
27090401001339020900 1.94.0391339031200 BOSCH MED17.7.2
27090401001339020900 1.94.0151339031300 BOSCH MED17.7.2
27090401001339021000 1.94.0431339031400 BOSCH MED17.7.2
27090407001339021300 1.94.0371339031900 BOSCH MED17.7.2
27090407001339021000 1.94.0231339031400 BOSCH MED17.7.2

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop