FORD F-150 Mk13 3.3L V6 Ti-VCT 216kW/290HP MG1CS019

ECU BOSCH MG1CS019 · 294 CV (216 kW) · 3300 cc · Benzina aspirato

ECU-databaseFORD › FORD F-150 Mk13 3.3L V6 Ti-VCT 216kW/290HP MG1CS019

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkFORD
ModelF-150 Mk13
Motor3.3L V6 Ti-VCT 216kW/290HP MG1CS019
Standaard vermogen294 CV / 216 kW
Cilinderinhoud3300 cc
BrandstofBenzina aspirato
VoertuigtypeLCV

ECU

FabrikantBOSCH
ModelMG1CS019
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Beschikbare tuning-opties:

  • Base timing
  • Desired engine load calculation
  • Part pedal combustion load limit
  • Exhaust gas temperature
  • Engine indicated torque
  • Engine indicated torque at stoichiometric
  • Factor to correct fuel delivery system
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Load limit at high effectiveness of LSPI mitigation
  • Load limit at low effectiveness of LSPI mitigation
  • Load limit at nominal effectiveness of LSPI mitigation
  • Maximum throttle angle opening for a given RPM
  • Overall LSPI load limit
  • Percent accelerator pedal angle to desired throttle angle
  • Final drive rear axle ratio
  • Driver torque request for the transmission - 1st gear
  • Driver torque request for the transmission - 2th gear
  • Driver torque request for the transmission - 3th gear
  • Driver torque request for the transmission - 4th gear
  • Driver torque request for the transmission - 5th gear
  • Maximum rear axle ratio
  • Minimum rear axle ratio
  • Driven tire circumference
  • Maximum tire circumference
  • Minimum tire circumference

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
JL3A-12B684-GAJL3A-12A650-AMB 1.94.004JL3A-14C204-BGG BOSCH MG1CS019
JL3A-12B684-GAJL3A-12A650-AMB 1.94.015KL3A-14C204-KD BOSCH MG1CS019

ECU-notities

Micro Infineon Tricore TC298TP This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata