FORD BRONCO Mk6 1.5L 16V Ecoboost 133kW/178HP MG1CS017

ECU BOSCH MG1CS017 · 181 CV (133 kW) · 1500 cc · Benzina sovralimentato

ECU-databaseFORD › FORD BRONCO Mk6 1.5L 16V Ecoboost 133kW/178HP MG1CS017

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkFORD
ModelBRONCO Mk6
Motor1.5L 16V Ecoboost 133kW/178HP MG1CS017
Standaard vermogen181 CV / 133 kW
Cilinderinhoud1500 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CS017
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Beschikbare tuning-opties:

  • Max threshold air mass flow throught compressor
  • Desired engine load calculation
  • Part pedal combustion load limit
  • Compressor pressure ratio limit for pumping and speed
  • Engine indicated torque
  • Engine indicated torque at stoichiometric
  • Load limit at high effectiveness of LSPI mitigation
  • Load limit at low effectiveness of LSPI mitigation
  • Load limit at nominal effectiveness of LSPI mitigation
  • Maximum indicated torque
  • Maximum indicated torque (overboost active)
  • Maximum throttle angle opening for a given RPM
  • Overall LSPI load limit
  • Percent accelerator pedal angle to desired throttle angle
  • Pressure ratio limit for overboost detection
  • Driver torque request for the transmission - 1st gear
  • Driver torque request for the transmission - 2th gear
  • Driver torque request for the transmission - 3th gear
  • Driver torque request for the transmission - 4th gear
  • Driver torque request for the transmission - 5th gear
  • Max tip at wastegate

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
KK1A-12B684-JAM1PA-14C204-SF 1.94.004M1PA-14C204-SF BOSCH MG1CS017

ECU-notities

Micro Infineon Tricore TC298TP This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata