DS DS7 CROSSBACK 2.0L 16V BlueHDI 130kW/174HP DCM7.1A

ECU DELPHI DCM7.1A · 177 CV (13 kW) · 2000 cc · Diesel sovralimentato

ECU-databaseDS › DS DS7 CROSSBACK 2.0L 16V BlueHDI 130kW/174HP DCM7.1A

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkDS
ModelDS7 CROSSBACK
Motor2.0L 16V BlueHDI 130kW/174HP DCM7.1A
Standaard vermogen177 CV / 13 kW
Cilinderinhoud2000 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantDELPHI
ModelDCM7.1A
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848Kbyte

Beschikbare tuning-opties:

  • Boost pressure limiter
  • Boost pressure limiter 2
  • Maximum engine boost pressure F (atmospheric pressure)
  • Boost pressure limit control
  • Boost pressure
  • Boost pressure F (temperature)
  • Load / throttle position reference
  • Load / throttle position reference 2
  • Load / throttle position reference 3
  • Max exhaust gas temperature curve for full load
  • Exhaust gas temperature threshold for component protection
  • Basic torque management at engine cranking
  • Injection period
  • Injection period 10
  • Injection period 2
  • Injection period 3
  • Injection period 4
  • Injection period 5
  • Injection period 6
  • Injection period 7
  • Injection period 8
  • Injection period 9
  • Injection opening time related to inj. pressure
  • Injection 1
  • J
  • Injection 3
  • Injection 4
  • Injection 5
  • Injection 6
  • Injection 7
  • Torque limiter
  • Torque limiter for diagnostic
  • Torque limiter for smoke limitation
  • Torque limiter for smoke limitation 2
  • Maximum indicated torque
  • Maximum indicated virtual torque
  • Maximum indicated virtual torque 2
  • Maximum engine power
  • Throttle air mass flow calculation
  • Throttle air mass flow calculation 2
  • Max torque profile
  • Max torque profile - AT
  • Max torque profile for diagnostic
  • Max torque profile - MT
  • Max torque profile for IAT sensor
  • Specific injection pressure limiter
  • Specific injection pressure limiter 2
  • Specific injection pressure limiter 3
  • Specific injection pressure limiter for diagnostics
  • Specific injection pressure limiter for EFT sensor
  • Specific injection pressure
  • Specific injection pressure 2
  • Specific injection pressure 3
  • Specific injection pressure 4
  • Specific injection pressure 6
  • Specific injection pressure 7
  • Specific pressure injection after starting
  • Specific pressure injection after starting 2
  • Driver torque request
  • Driver torque request for high speed
  • Driver torque request for low speed
  • Driver torque request from MAP sensor
  • Driver torque request from MAP sensor - interpolation
  • Driver torque request at the start
  • Driver torque request for reverse gear
  • Torque limiter for gear-shift too long
  • Torque limiter for selected gear
  • Torque limiter for the APS/BPS
  • Torque limiter for EFT sensor
  • Torque limit table for EOT sensor
  • Torque limit table for the rail pressure demand
  • Torque limit table for ECT sensor
  • Take-off torque law from MAP sensor

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
98180350809818035080 1.00.0089696389780 DELPHI DCM7.1A

ECU-notities

Microprocessor TC297TP_96 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata