DS DS3 CROSSBACK 1.2L 12V PureTech 96kW/129HP VD56.x

ECU CONTINENTAL-SIEMENS-VDO VD56.x · 131 CV (96 kW) · 1200 cc · Benzina sovralimentato

ECU-databaseDS › DS DS3 CROSSBACK 1.2L 12V PureTech 96kW/129HP VD56.x

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkDS
ModelDS3 CROSSBACK
Motor1.2L 12V PureTech 96kW/129HP VD56.x
Standaard vermogen131 CV / 96 kW
Cilinderinhoud1200 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantCONTINENTAL-SIEMENS-VDO
ModelVD56.x
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848Kbyte

Beschikbare tuning-opties:

  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Advance correction
  • Boost pressure
  • Lambda correction for engine temperature after starting
  • Load / throttle position reference
  • Load / throttle position reference 2
  • Load / throttle position reference 3
  • Filling factor limit
  • Filling factor limit 2
  • Volumetric efficiency high pressure fuel pump
  • Maximum injection quantity
  • J
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter 4
  • Torque limiter 5
  • Torque limiter 6
  • Torque limiter 7
  • Maximum possible engine charge
  • Maximum engine power
  • Optimal engine moment
  • Driver torque request
  • Driver torque request for high speed
  • Driver torque request for low speed
  • Driver torque request at the start
  • Driver torque request for reverse gear
  • Torque limiter in recovery mode

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
9815023380 1.73.0049893648180 CONTINENTAL-SIEMENS-VDO VD56.x
9815023380 1.73.0029894077180 CONTINENTAL-SIEMENS-VDO VD56.x

ECU-notities

Microprocessor TC297TP_96 ATTENTION: the ECU can be modified via OBDII with New Genius ONLY after the unlock through the PATCH UNLOCK with New Trasdata. After the unlock it is possible to reprogram the ECU through OBDII port with New Genius. To work on this ECU you can use NewTrasdata