BRILLIANCE AUTO GROUP SY650 2.0L L4 16V 135kW/181HP MEVD17.2.9

ECU BOSCH MEVD17.2.9 · 184 CV (135 kW) · 2000 cc · Benzina sovralimentato

ECU-databaseBRILLIANCE AUTO GROUP › BRILLIANCE AUTO GROUP SY650 2.0L L4 16V 135kW/181HP MEVD17.2.9

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkBRILLIANCE AUTO GROUP
ModelSY650
Motor2.0L L4 16V 135kW/181HP MEVD17.2.9
Standaard vermogen184 CV / 135 kW
Cilinderinhoud2000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMEVD17.2.9
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Boost pressure
  • Boost pressure 2
  • Desired engine load calculation
  • Maximum torque limitation at clutch
  • Characteristic line correction factor for pressure ratio for turbocharger overspeed protection
  • Gearbox maximum torque allowed
  • HFM/HLM threshold for diagnosis
  • High pressure fuel pump setpoint
  • Intake valve lift
  • Intake valve lift - full load
  • Torque limiter 2
  • L
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Boost pressure linearization
  • Knock detection factor
  • Speed limiter
  • Speed limiter 3
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Maximum pressure ratio limit depending on ECT
  • Requested engine filling
  • Driver torque request
  • Wastegate duty-cycle

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
08643743 1.98.00208647892 BOSCH MEVD17.2.9

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata