VOLKSWAGEN NEW BEETLE 1.4L 16V 55kW/74HP ME7.5.10

Calculateur BOSCH ME7.5.10 · 75 CV (55 kW) · 1400 cc · Benzina aspirato

Base de données calculateursVOLKSWAGEN › VOLKSWAGEN NEW BEETLE 1.4L 16V 55kW/74HP ME7.5.10

Retrouvez les identifiants du firmware (numéros hardware, software et mise à jour), les options de tuning disponibles et comment obtenir le fichier d'origine ou reprogrammé.

✓ Tuning par fichier (flash) 3 versions firmware

Données véhicule

MarqueVOLKSWAGEN
ModèleNEW BEETLE
Moteur1.4L 16V 55kW/74HP ME7.5.10
Puissance d'origine75 CV / 55 kW
Cylindrée1400 cc
CarburantBenzina aspirato
Type de véhiculeAuto

Calculateur

FabricantBOSCH
ModèleME7.5.10
Mémoire / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Opérations / options de tuning disponibles:

  • Avance principale
  • Avance optimal
  • Calcul de charge du moteur désirée
  • Température des gaz d'échappement
  • Enrichissement Lambda pour la protection des composants
  • Lambda demandée
  • Calcul du débit massique d'air d'accélérateur
  • Couple optimal du moteur
  • Demande de couple
  • Demande de couple en marche arrière
  • Gestion angle papillon

Identifiants firmware (3)

N° HardwareN° Software (chip)VersionLogiciel de mise à jourCalculateur
02612068521037363380 1.21.003036906032C 4317 BOSCH ME7.5.10
02612080431037366102 1.21.019036906032AF 4576 BOSCH ME7.5.10
02612080431037370925 1.21.004036906032AF 5745 BOSCH ME7.5.10

Notes calculateur

Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator. To work on this ECU you can use NewTrasdata This Setting File can be used for serial system : Genius or NewGenius.
Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator. This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata