YAMAHA MOTORCYCLES T?n?r? 700 25->25 55kW

ECU DENSO Bxx-8591A-xx · 73 CV (54 kW) · 690 cc · Benzina aspirato

ECU-databaseYAMAHA MOTORCYCLES › YAMAHA MOTORCYCLES T?n?r? 700 25->25 55kW

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkYAMAHA MOTORCYCLES
ModelT?n?r? 700
Motor25->25 55kW
Standaard vermogen73 CV / 54 kW
Cilinderinhoud690 cc
BrandstofBenzina aspirato
VoertuigtypeMoto

ECU

FabrikantDENSO
ModelBxx-8591A-xx
Geheugen / EPROMMicro RENESAS core RH850

Beschikbare tuning-opties:

  • AFR full load/WOT
  • AFR for IAP
  • AFR for TPS
  • Base timing
  • Optimal spark timing/MBT
  • Advance correction
  • Coil charge time
  • Engine idle vs. ECT sensor
  • Rpm threshold fuel cut
  • Rpm threshold fuel cut 2
  • Injection for IAP
  • Injection for TPS
  • RPM Limiter
  • Speed limiter
  • Optimal engine moment
  • Optimal engine moment 2
  • Throttle angle limitation
  • TAMCM
  • Throttle angle management - correction - mode 2
  • Throttle angle management - correction - mode 3
  • Throttle angle management - correction - mode 4
  • TAMM
  • Cooling fan activation
  • Engine torque limiter depending on vehicle speed

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
14008000 1.00.014D081_14008000 DENSO Bxx-8591A-xx
1289C000 1.00.004BRL3_1289C000 DENSO Bxx-8591A-xx
14007001 1.00.007D071_14007001 DENSO Bxx-8591A-xx
14008000 1.00.022D081_14008000 DENSO Bxx-8591A-xx
14008040 1.00.013D082_14008040 DENSO Bxx-8591A-xx

ECU-notities

Microprocessor R7F701201 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor R7F701201 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata ATTENTION - 35kW reduced power version file.