VOLVO V70 Mk3 2.5L 20V TURBO 147kW/200HP ME9.0

ECU BOSCH ME9.0 · 200 CV (147 kW) · 2500 cc · Benzina sovralimentato

ECU-databaseVOLVO › VOLVO V70 Mk3 2.5L 20V TURBO 147kW/200HP ME9.0

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkVOLVO
ModelV70 Mk3
Motor2.5L 20V TURBO 147kW/200HP ME9.0
Standaard vermogen200 CV / 147 kW
Cilinderinhoud2500 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME9.0
Geheugen / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Boost pressure limit control
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Pressure ratio depending on IAT
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02612091081037395095 1.70.008P020F400 BOSCH ME9.0
02612091081039S27438 1.70.012F400-12A650-_F BOSCH ME9.0

ECU-notities

The only way to modify this ECU is by using the BDM system: TRASDATA or NEW TRASDATA. Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocesor Motorola MPC561/2/3/4. WARNING! ECU MED9 - IX/CL = injection at full load, decrease the values to enrich the injection